Zhuhai Sunlu Industrial Co., Ltd.

3D Printing Pen Tutorial

Power on
Connect the DC5V power cable included with the product to a 5V/2A power adapter or an external mobile power supply, when the LCD display on the product has characters to indicate that the device has been powered into standby mode.
3D Printing Pen warm-up
Tap the "extrusion button", the red LED lights up, it means the device enters the preheating state (preheating about 70℃-100℃), when the red LED turns from red to green, the preheating is over.
Loading filament
When the light turns from red to green, it indicates that the preheating is over and the device enters the working state. Insert the filament into the "Feed/Returned material" at the end of the pen and press the "extrusion button", then you can choose any of the following two ways to load the consumables. When there is filament extruded from the nib nozzle, it will be loaded successfully, and you can start printing at this time.
Printing speed/temperature adjustment
When you need to adjust the printing speed/temperature according to the filament discharge, tap the "Extrude button" to stop the pen from extruding, then tap the "Temperature button +/-" and "Speed button +/-" to select the appropriate printing speed and temperature. Finally tap "Extrude button" again to dispense the filament normally.
Replace/Exit filament
When the LED light is green, press and hold the "return button" for 3 seconds, release the button, then the filament will be continuously transported and withdrawn by the built-in motor. When the filament stops moving backward, remove the material from the end of the product. Press the "Return button" at the same time, and the device stops returning filament. (After about 50 seconds of continuous feeding, the motor will automatically stop working).
End of printing
At the end of printing, you must exit all filament, otherwise it will affect the normal use of the 3d printing pen in the future.

3D Printing Pen Tutorial

Power on
Connect the DC5V power cable included with the product to a 5V/2A power adapter or an external mobile power supply, when the LCD display on the product has characters to indicate that the device has been powered into standby mode.
3D Printing Pen warm-up
Tap the "extrusion button", the red LED lights up, it means the device enters the preheating state (preheating about 70℃-100℃), when the red LED turns from red to green, the preheating is over.
Loading filament
When the light turns from red to green, it indicates that the preheating is over and the device enters the working state. Insert the filament into the "Feed/Returned material" at the end of the pen and press the "extrusion button", then you can choose any of the following two ways to load the consumables. When there is filament extruded from the nib nozzle, it will be loaded successfully, and you can start printing at this time.
Printing speed/temperature adjustment
When you need to adjust the printing speed/temperature according to the filament discharge, tap the "Extrude button" to stop the pen from extruding, then tap the "Temperature button +/-" and "Speed button +/-" to select the appropriate printing speed and temperature. Finally tap "Extrude button" again to dispense the filament normally.
Replace/Exit filament
When the LED light is green, press and hold the "return button" for 3 seconds, release the button, then the filament will be continuously transported and withdrawn by the built-in motor. When the filament stops moving backward, remove the material from the end of the product. Press the "Return button" at the same time, and the device stops returning filament. (After about 50 seconds of continuous feeding, the motor will automatically stop working).
End of printing
At the end of printing, you must exit all filament, otherwise it will affect the normal use of the 3d printing pen in the future.

3D Printing Pen Tutorial

3D Printing Pen Tutorial

分享至微信

分享至微信